Canon Omnera 500A Operator's Manual page 74

User Interface
Automatic Collimator Control
User settings – Settings
Image
Localization
Audio
System Sound
LCD
Logotype
In the Settings tab, it is possible to adjust the following:
• Preview Image (not applicable for CR systems)
• Localization unit selection
• Audio key click, On/Off
• System sound, On/Off
• LCD brightness, Plus/Minus
• Arcoma logotype in display, On/Off
– Image preview on
– Localization
– Audio Key Click
– Sound on
LCD
The display brightness can be adjusted. There is also a setting if the logo shall be shown or
not.
OMNERA®
Preview on
Unit cm
Key Click
Beep when aligned,
Sound 1 on
tracking.
Brightness
On
Fig. 3-13 User settings – Settings
By selecting this, a small preview image will
be shown next to the Active Protocol name
(see figure on page).
Changes between cm and inch,
for collimator light width and height values
and SID/H.
By selecting this, a key click will be heard
when touching the System display.
By selecting this, a beep will be heard when
OTC is aligned with the detector, at
tracking.
1000-095-071-EN Rev. 1.1
Page 66
Operator´s Manual
2020-09-14