4.11.1.3 Method to Remove the 14x17 Detector, Wallstand
The method of removing the detector from the detector tray is as follows.
1. To remove the detector, in the step 2 of "Method to set the detector", unlock the connector
by pulling the latch of the detector tray in the direction of the arrow.
Note!
• Depending on left or right operated Wallstand, the location of the detector tray and position
of button and latches is different.
Operator´s Manual
2020-09-14
Operating the System
Fig. 4-37 Unlocking the detector latch
1000-095-071-EN Rev. 1.1
Page 135
Detector, Wallstand
OMNERA®