St950 Plus Controller Cabinet; The Primary Plus + Controller Cabinet - Siemens ST950 Plus+ User Manual

ST950 Plus+ User Manual
ST950 P
LUS
3
This section details the main elements, of the ST950 Plus
controller cabinet.
The Primary Plus
Figure 12 and Figure 13 below show the ST950 Plus
Controller Cabinet.
The Master Switch Panel and two CIC cards are all installed on the right-hand side panel of the
cabinet.
The 24V PSU, the 48V PSUs along with the redundancy modules, collectively known as the Power
Bank, a third CIC card and some other miscellaneous equipment are installed on the left hand side
panel of the cabinet. The 48V PSUs for a third CIC are mounted on the bottom of the rear panel.
The 19" Controller Rack is installed in an equipment swing frame at the front of the cabinet; this
frame can be swung open to enable access to the rear of the frame and to the cards and
components installed in the cabinet.
The ST950 Plus controller cabinet is normally supplied on an appropriate pallet. Transport of the
+
cabinet can be via Pallet truck or using recyclable wheels.
Cabinet Stool
The ST950 Plus+ controller cabinet is not provided with the Cabinet Stool. Several stool types
may be used with ST950 Plus
section 6.4 for details.
Figure 11 : ST950 Plus
ST950 Plus+ User Manual
C C
+
ONTROLLER ABINET
Controller Cabinet
+
cabinet and must be ordered as a separate item. Reference
+
Cabinet and Recyclable Wheels
+
Page 27 of 176
667/HE/53000/000
system, that are held within the
+
controller CPU card fitted in a standard ST950
+
Issue 2
Unrestricted