Siemens ST950 Plus+ User Manual page 159

ST950 Plus+ User Manual
6. Fitting is the reversal of removal. In the case of a Combined Nearside with two ByPass
connections, ensure the left-hand ByPass connection is to Wait/PDU and the right-hand
ByPass connection is to Nearside (no crossover of ribbon cables).
Take note of the New Serial Number
For a single Node, the process to acknowledge an update does not require prior knowledge of the Serial
Number. However, it is good practice to note the New Serial Number and update any backups of the
Design Layout (paper or Electronic).
If multiple nodes are being replaced, then the Serial Number will need to be noted for configuration
update.
7. At the controller, in the Fault Table, the User is expected to 'Acknowledge' the change in
Node and then press the L3 button to confirm. Note: The use of the 'Release' Button is not
required.
ST950 Plus+ User Manual Page 159 of 176
667/HE/53000/000
Issue 2
Unrestricted