Siemens ST950 Plus+ User Manual page 124

ST950 Plus+ User Manual
Ethernet Configuration
Ethernet can be fully configured manually if required but configuration can be minimised by using
DHCP.
To connect the equipment to Stratos perform the following:
1. Set the date and time (System - Settings - System Date & Time - Set System Date & Time
web page).
2. On the System - Settings - Comms – Stratos web page:
a. Set the Tenant Pass Phrase.
b. Set the Site Location.
c. Set the Site Name.
3. Set the profile to Stratos (System – Settings web page).
4. Check that Ethernet is suitably configured (System - Settings - Comms - DSL/Fibre web
page). Using the Stratos profile sets this to DHCP. If this not suitable then configure as
required.
5. Connect the Ethernet port to a network which has connectivity to the services described
above.
Setting the Site Name, Site Location & Tenant Pass Phrase
These items are set on the System – Settings – Comms – Stratos configuration web page.
Specifying a Tenant Pass Phrase prior to initial connection allows the equipment to be
automatically allocated to the specified tenant on initial connection to Stratos. If the Tenant Pass
Phrase is not specified at the time of initial connection then the equipment will be allocated to the
Siemens Support team who can then make the allocation when required based on the outstation
name, unique site id and destination tenant. This item has no effect after initial connection to
Stratos.
Setting the profile to Stratos
Equipment is supplied configured for use in non-Stratos systems. To configure it for use with
Stratos, visit the System – Settings configuration web page and set the Profile to Stratos.
ST950 Plus+ User Manual Page 124 of 176
667/HE/53000/000
Issue 2
Unrestricted