Re-Fit The Controller Electronics (If Applicable) - Siemens ST950 Plus+ User Manual

ST950 Plus+ User Manual
Site cabling must be tested against the requirements of the Installation and Commissioning
Handbook – Installation Testing (General) (667/HE/20664/000).
Cable Testing
Do NOT test any site cabling without reference to this document (667/HE/20664/000).
Additionally, with or without testing the Traffic Signal Installation Completion Certificate
(667/HE/20664/001) needs to be completed as part of the completion of site commissioning
(see Section 6.8).
Additionally, the cable testing should not be carried out once the Node are connected to the
system.
6.6.7 Fitting the Cabinet to the Stool
Clean the top surface of the stool and the lower surface of the cabinet that will be in contact when
the cabinet is fitted. Apply a bead of silicone sealant around the edge of the stool.
Apply silicone sealant (ref. part no. 996/4/22026/100
ensure that a good seal between the stool and the cabinet will be made).
The cabinet is installed by lowering it onto the stool and fitting the retaining bolts.
When fitting the cabinet onto the stool, make sure that all the cables are in their correct position
with regard to the SEB. Once the cabinet has been secured, moving of the cables could cause
damage.
Back-Fill and Base Sealant
If the Plus+ Controller Cabinet is being mounted on a Standard Controller Stool, then there will also
need to be a process of backfill and base sealant application.
Detailed information can be found in the Stool Installation Document (667/CC/53060/000).

Re-fit the Controller Electronics (if applicable)

Re-fit the electronics into the controller case, checking that:
• All cards are seated correctly in their sockets
• All plugs and sockets are securely mated
•
All fixings are tight – especially those securing cards to side or back panels of the cabinet.
ST950 Plus+ User Manual
)
to the top surface of the stool (enough to
Page 110 of 176
667/HE/53000/000
Issue 2
Unrestricted