Siemens ST950 Plus+ User Manual page 177

Appendix
On completion of the firmware download, the user is directed to the fault table in order to
review any further actions.
Plus
If the CIC and the Nodes are both being upgraded, the user should only power cycle the
controller on completion of both download phases. In some cases that may also be part of the
primary/secondary update procedure. Please refer to the Fault Table for specific instructions.
ST950 Plus+ User Manual
Figure 85 : Node Download Completed
+
Peripheral Download Completion
Page 177 of 176
667/HE/53000/000
Issue 2
Unrestricted