English
4. LP-1 AND CLUSTER INSTALLATION
X
LP-1
X
The LP-1 link plug is required for creating VIO-C clusters. It is equipped with 2 buttons X for quick coupling. The
number of required LP-1 link plugs varies depending on the number of elements and whether the installation is in
flown or stacked configuration. Two people are required to connect the LP-1, following the sequence below:
1) align the pins to the holes of 2 speakers in the mechanical seats C or E, as shown in the figure below
2) press and hold the buttons X down to insert LP-1
3) release the buttons X
The figure at the top right side shows the possible connection positions in a cluster: T (top), E (external), I
(internal), L (lower). According to this nomenclature, depending on whether the installation is with one or
two layers and whether it is flown or stacked, the table below shows the LP-1 numbers required for correct
installation.
STACKED 1-LAYER CLUSTER
No. of VIO C speakers per layer No. of LP-1 link plugs
2
3
4
FLOWN 1-LAYER CLUSTER
No. of VIO C speakers per layer No. of LP-1 link plugs
2
3
4
VIO C SERIES
X
X
1 (T)
2 (T)
3 (T)
1 (L)
2 (L)
3 (L) + 1 (T)
E
I I
STACKED 2-LAYER CLUSTER
No. of VIO C speakers per layer No. of LP-1 link plugs
2
3
4
FLOWN 2-LAYER CLUSTER
No. of VIO C speakers per layer No. of LP-1 link plugs
2
3
4
T
L
1 (T) + 2 (E)
2 (T) + 2 (E)
3 (T) + 2 (E)
1 (L) + 2 (E) + 2 (I)
2 (L) + 2 (E) + 4 (I)
1(T) + 2(E) + 3(L) +6(I)
Code 420120341 REV. 1.0
E
33
Need help?
Do you have a question about the VIO C Series and is the answer not in the manual?