Table of Contents
Advertisement
5
Troubleshooting
4. Click OK.
The IP30 returns to its factory defaults - this process might take up
30-60 seconds to finish.
At the end of the process the gateway restarts automatically and the
Gateway restart confirmation page appears.
5. Click OK.
The gateway is restarted and within one minute the IP30 Welcome
page appears.
To reset the IP30 to factory defaults using Reset
1. Make sure the IP30 is powered on.
2. Using a sharp object, press the RESET button on the back of
3. Allow the IP30 to boot-up until the system is ready (PWR/SEC
Warning
If you choose to reset the IP30 by disconnecting the power cable and then
reconnecting it, be sure to leave the IP30 disconnected for at least three
seconds, or the IP30 might not function properly until you reboot it as
described below.
Rebooting the IP30
If the IP30 is not functioning properly, rebooting it will often solve
the problem.
To reboot the IP30
1. In the Navigation Bar click Setup.
132
A confirmation message appears.
the IP30 steadily for a few seconds and then release it.
LED flashes slowly or illuminates steadily in green light).
The Internet page appears.
IP30
Advertisement
Table of Contents
