Table of Contents
Advertisement
4
VPN Configuration
Setting up IP30 Satellite
Configure a VPN tunnel between two IP30 Satellite devices (site-
to-site VPN).
To set up IP30 Satellite
1. Specify the IP address of IP30 Satellite on the remote IP30
2. Enter the Shared Secret (a password that is known to both of
To set up the remote IP30 Satellite
1. Specify the IP address of your IP30 Satellite.
2. Enter the Shared Secret (a password that is known to both the
Satellite to VPN-1 (Site-to-Site VPN)
The IP30 Satellite to VPN-1 or Check Point v4.1, NG, FP1, FP2 or
FP3 configuration enables you to establish site-to-site VPN
connections between an IP30 Satellite site-to-site VPN gateway
and a VPN-1 site-to-site VPN gateway.
Note
In this solution model, both the VPN-1 and IP30 Satellite Site-to-Site VPN
gateways must have a static IP address.
The figure below shows an implementation of the IP30 Satellite to
Check Point VPN-1 solution, in which two IP30 Satellite devices
are connected to a VPN-1 site-to-site VPN gateway.
100
Satellite.
the IP30 Satellite devices).
IP30 Satellite devices.)
Nokia IP30 User Guide
Advertisement
Table of Contents
