Table of Contents
Advertisement
2. If you are using IP Satellite, add the demo Check Point VPN
site, using the procedure Adding and Editing VPN Sites using
IP30 Tele, as follows:
a. In the Welcome to the VPN Site Wizard dialog box, select
b. In the VPN Gateway Address dialog box, enter
c. In the VPN Network Configuration dialog box, select
3. Log on to the demo site, using "vpndemo" as your username
and password.
4. Surf to http://207.40.230.22
The Check Point VPN-1 SecuRemote Demo Site should open and
inform you that you successfully created a VPN tunnel.
I changed the network settings to incorrect values and am
unable to correct my error. What should I do?
Reset the network to its default settings using the button on the
back of the IP30 unit.
I am using the IP30 with another DSL/Cable router, and I am
having problems with some applications.
The IP30 performs Network Address Translation (NAT). It is
possible to use the IP30 behind another device that performs NAT,
such as a DSL router or Wireless router, but the device will block
all incoming connections from reaching your IP30.
To fix this problem, do ONE of the following. (The solutions are
listed in order of preference.)
Consider whether you really need the router. The IP30 can be
used as a replacement for your router, unless you need it for
some additional functionality that it provides, such as Wireless
access.
If possible, disable NAT in the router. Refer to the router's
documentation for instructions on how to do this.
IP30
Remote Access VPN.
207.40.230.20 in the VPN Gateway field.
Download Configuration.
Frequently Asked Questions
127
Advertisement
Table of Contents
