Eighteeth E-CONNECT User Manual page 37

27、EMC Tables
Guidance and manufacturer's declaration – electromagnetic emissions
The E-connect is intended for use in the electromagnetic environment specified below.
The customer or the user of the E-connect should assure that it is used in such an
environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic
emissions
IEC61000-3-2
Voltage
fluctuations/flicker
emissions
IEC 61000-3-3
Guidance and manufacturer's declaration – electromagnetic immunity
The E-connect is intended for use in the electromagnetic environment specified below.
The customer or the user of the E-connect should assure that it is used in such an
environment.
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transients/bursts
Compliance
Group 1
Class B
Class A
Complies
IEC 60601 test
level
+/- 8 kV contact
+/- 2 kV, +/- 4 kV,
+/- 8 kV, +/- 15 kV
air
±2kV
100kHz repetition
frequency
Electromagnetic environment - guidance
The E-connect uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
The E-connect is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Compliance
level
+/- 8 kV contact
+/- 2 kV, +/- 4 kV,
+/- 8 kV, +/- 15
kV air
±2kV
100kHz repetition
frequency
35
Electromagnetic
environment - guidance
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should be
at least 30 %.
Mains power quality should
be that of a typical