Landis+Gyr E650 Series User Manual page 32

32/84
Seal component
© Landis+Gyr
If the meter has no communication unit, this is replaced by a dummy case.
An additional component, which is easy to install, allows the use of a
standard padlock instead of a utility seal.
Figure 23. Front door sealing using a padlock
The seal component is stowed away in a holder under the front door when
not in use.
Figure 24. Stowage of seal component when not in use
The seal component is installed as follows:

Slide the seal component into the vertical slot at an angle, as shown,
(position 1) until it contacts the rear wall.

Now turn the seal component until it is horizontal and slide it down into
position 2 as illustrated. The two bulges firmly fix the seal component
into the lateral grooves.
D000030108 en m – E650 Series 3 – ZMD300AT/CT – User Manual
Mechanical construction