Landis+Gyr E650 Series User Manual page 76

76/84

© Landis+Gyr
Figure 70. Battery compartment
3. Press on the latch of the plastic battery holder until it releases and then
withdraw the battery holder with the old battery.
Figure 71. Removing the battery
4. Mark the current date on the new battery.
5. Withdraw the old battery from the holder and insert the new battery.
6. Push the battery holder with battery into the battery compartment until
the latch engages.
7. Reset the battery hours counter to zero with the relevant formatted
command (see section 5.8 "Input of formatted commands") or in the
set mode (see section 5.9 "Set time and date, ID numbers, battery
time").
8. Close the front door.
9. Re-seal the front door.
10. Dispose of old batteries as hazardous waste in accordance with local
regulations.
Checking time-of-day and date
After inserting the battery, check the time-of-day and date without power
applied and set these values again if necessary.
D000030108 en m – E650 Series 3 – ZMD300AT/CT – User Manual
Maintenance