thomann Stairville LED-Commander 16/2 User Manual page 17

Deleting a program step
Deleting chaser sequences or a scene
Assigning DMX channels to AUX chan‐
nels
½ RECORD] down for three seconds to switch to Program/
1.
Hold [PROGRAM
Record mode.
2.
Use [CHASE] to select the sequence you wish to delete a program step from. To
do this, switch between the two memory banks using the toggle button if
need be.
3. ½ IN SET] and then use and to select the step number you wish
Press [MIDI
to delete.
½ DEL] to delete the program step.
4.
Press [TAP
ð All LEDs flash three times.
½ RECORD] down for three seconds to exit recording mode.
5.
Hold [PROGRAM
1.
De-select all active FIXTURE, SCENE and CHASE channels (all blue LEDs off).
½ RECORD] down for three seconds to switch to Program/
2.
Hold [PROGRAM
Record mode.
3. Switch between the two memory banks 'CHASE' and 'SCENE' using the toggle
button if need be.
4. ½ DEL] and simultaneously the chase button of the sequence or
Press [TAP
scene you wish to delete.
Wait a few seconds until the LEDs have gone out.
½ RECORD] down for three seconds to exit recording mode.
5.
Hold [PROGRAM
½ CLEAR] down for three seconds to switch to Program/Record
1.
Hold [PATCH
mode.
2. Use [FADE] and [SPEED] to select the DMX channel you wish to assign.
3.
Press [AUX1] or [AUX2] assign the DMX channel to the corresponding AUX
channel.
4. Repeat steps 2 and 3 to assign as many other DMX channels as you wish.
½ CLEAR] down for three seconds to exit recording mode.
5.
Hold [PATCH
As soon as DMX channels are assigned to an [AUX] button, the value of the
assigned channels is set to 255 whenever this button is activated.
LED-Commander 16/2
Operating
17