thomann Stairville LED-Commander 16/2 User Manual page 16

Operating
Programming chaser sequences
Inserting a program step
16
½ RECORD] down for three seconds to switch to Program/
1.
Hold [PROGRAM
Record mode.
2.
Use [CHASE] to select the required sequence. To do this, switch between the
two memory banks using the toggle button if need be.
ð The associated CHASE LED lights up.
3.
Use [FIXTURE] to select the channel you wish to program.
4.
Use the Flash controllers 1 to 8 to set the required values.
½ RECORD] to save the new values.
5.
Press [PROGRAM
ð All of the device LEDs flash briefly and the following values appear on the
display:
6.
Repeat steps 2 to 5 to add further program steps.
7. ½ RECORD] down for three seconds to exit recording mode.
Hold [PROGRAM
½ RECORD] down for three seconds to switch to Program/
1.
Hold [PROGRAM
Record mode.
2. Use [CHASE] to select the sequence you wish to expand. To do this, switch
between the two memory banks using the toggle button if need be.
½ IN SET].
3.
Briefly press [MIDI
ð The associated display LED flashes.
4.
If necessary, use and
insert the program step.
5.
Use [FIXTURE] to select the channel you wish to program.
6.
Use the Flash controllers 1 to 8 to set the required values.
7. ½ RECORD] to save the new values.
Press [PROGRAM
ð All display LEDs flash three times.
8. Repeat steps 4 to 7 to add further program steps. The 16 memory locations can
be assigned a total of 250 program steps.
9. ½ RECORD] down for three seconds to exit recording mode.
Hold [PROGRAM
DMX controller
to select the step number under which you wish to