thomann Stairville LED-Commander 16/2 User Manual page 15

Playing scenes
Programming scenes
Playing chaser sequences
1. De-select all active FIXTURE channels.
½ CLEAR] briefly to delete the starting values of the fader function.
2.
Press [PATCH
3. Use [SCENE] to select the required scene. To do this, switch between the two
memory banks using the toggle button if need be.
You can link multiple scenes so that they run in parallel. Use [FADE] to con‐
trol the fade-in and fade-out time for all scenes. The LEDs of all selected
scenes light up blue.
1. ½ RECORD] down for three seconds to switch to Program/
Hold [PROGRAM
Record mode.
2.
Use [FIXTURE] to select the channel you wish to program.
3. Use the Flash controllers 1 to 8 to set the required values.
½ RECORD] and then for around one second the button of the
4.
Press [PROGRAM
scene you wish to overwrite.
ð All device LEDs flash briefly.
5. ½ CLEAR] down for three seconds to exit recording mode.
Hold [PATCH
Scenes that are already allocated are indicated by the LED lighting up blue
next to the relevant scene button. These can also be overwritten if required.
1. De-select all active FIXTURE channels (all blue FIXTURE LEDs off).
½ CLEAR] briefly to delete the starting values of the fader function.
2.
Press [PATCH
3. Use [CHASE] to select the required sequence. To do this, switch between the
two memory banks using the toggle button if need be.
You can activate multiple chasers simultaneously which are then played in
sequence. The output value of scenes that may be active always has pri‐
ority.
LED-Commander 16/2
Operating
15