Analog Input (Ai) Commands (Acknowledged) - Danfoss VLT 2800 Manual

Analog Input (AI) Commands (Acknowledged)

ACK 1 - 1
ACK 1 - 1
ACK 1 - 1
ACK 1 - 1
ACK 1 - 1
ACK 1 - 1
ACK 1 - 1
ACK 1 - 1
ACK 2 - 1
ACK 2 - 1
ACK 2 - 1
ACK 2 - 1
ACK 2 - 1
ACK 2 - 1
ACK, 7 2 1
no
action
ACK 7 3 1
no
action
ACK, 7 7 1
no
action
ACK, 7 8 1
no
action
MG.90.C1.02 - VLT is a registered Danfoss trademark
1-24 1 Byte Read
Analog Input
1-24 2 Byte Read
Analog Input
1-24 3 Float Read
Analog Input
1-24 8 Float Read
Analog Input
1-24 9 Float Read
Analog Input
1-24 10 Float Read
Analog Input
1-24 11 Float Read
Analog Input
1-24 12 Float Read
Analog Input
1-24 1 Byte Write
Analog Input
1-24 8 Float Write
Analog Input
1-24 9 Float Write
Analog Input
1-24 10 Float Write
Analog Input
1-24 11 Float Write
Analog Input
1-24 12 Float Write
Analog Input
1-24 - Float Override
Analog Input
1-24 - - Override
Release
1-24 - - Write
Analog Input
Attributes
1-24 - - Read Analog
Input
Attributes
VLT ® 2800 Metasys N2
- Read Object Configuration attribute
associated with each individual point.
- 1) Read Object Status attribute
associated with each individual point.
- 2) Read Analog Input Value attribute
associated with each individual point.
- Read Low Alarm attribute associated
with each individual point.
- Read Low Warning attribute associated
with each individual point.
- Read High Warning attribute associated
with each individual point.
- Read High Alarm attribute associated
with each individual point.
- Read Differential attribute associated
with each individual point.
- Write to Object Configuration attribute
associated with each individual point.
- Write to Low Alarm Limit attribute
associated with each individual point.
- Write to Low Warning Limit attribute
associated with each individual point.
- Write to High Warning Limit attribute
associated with each individual point.
- Write to High Alarm Limit attribute
associated with each individual point.
- Write to Differential attribute associated
with each individual point.
- Analog inputs are "outputs" from the VLT
2800 and should not be written over by
the network controller.
- Analog inputs are "outputs" from the VLT
2800 and should not be written over by
the network controller.
- Optional command for slave devices.
Only used for N2 commissioning
purposes.
- Optional command for slave devices.
Only used for N2 commissioning
purposes. Not to be implemented at this
time.
9