Analog Output (Ao) Commands (Acknowledged) - Danfoss VLT 2800 Manual

Analog Output (AO) Commands (Acknowledged)

ACK 1 - 3
ACK 1 - 3
ACK 1 - 3
ACK 2 - 3
ACK 7 2 3
ACK 7 3 3
ACK, 7 7 3
no
action
ACK, 7 8 3
no
action
MG.90.C1.02 - VLT is a registered Danfoss trademark
1-2 1 Byte Read Analog
Output
1-2 2 Byte Read Analog
Output
1-2 3 Float Read Analog
Output
1-2 1 Byte Write Analog
Output
1-2 - Float Override
Analog
Output
1-2 - - Override
Release
1-2 - - Write Analog
Output
Attributes
1-2 - - Read Analog
Output
Attributes
VLT ® 2800 Metasys N2
- Read Object Configuration
attribute associated with each
individual point.
- Read Object Status attribute
associated with each individual
point.
- Read Current Value attribute
associated with each individual
point.
- Write to Object Configuration
attribute associated with each
individual point.
- Write to analog output current
value (frequency setpoint).
- Set the current value, the value
that it was before the 1. Override
Command was issued
- Optional command for slave
devices. Only used for N2
commissioning purposes. Not to
be implemented at this time.
- Optional command for slave
devices. Only used for N2
commissioning purposes. Not to
be implemented at this time.
11