Mounting Of The Bottom Cap Cable (Optional) - Panasonic SF4B-F31G(V2) Instruction Manual

2-4-2 Mounting of the Bottom Cap Cable (Optional)

The cable is not enclosed with this device.
Mount the bottom cap cable (optional) in accordance with the following procedure.
<Reference>
There are two types of the bottom cap cable, 8-core type and 12-core type, and in addition to these types,
two more types are available for the bottom cap cable, discrete wire type and connector type. Select the
bottom cap cable as usage.
The length of the bottom cap cable differs depending on the model No.
Type
Discrete wire type
8-core
Connector type
Discrete wire type
12-core
Connector type
<Mounting method>
1. Insert the connector of the bottom cap cable (optional) into the connector of this device.
When inserting the connector, fit the cable to the groove of this device.
2. Tighten the two M2.6 screws. The tightening torque should be 0.3N·m or less.
24
● Do not lose any screws during extension / dismantling.
● The bottom cap cables are distinguished with the color of the connectors, the
color of the connector for emitter is gray and that of the receiver is black. Con-
nect the cable to emitter and receiver without fail using their colors as the guide.
● The packing is attached to the connector of the bottom cap cable.If the packing
is not attached correctly, reattach the packing as shown in the figure below, and
mount to this device.
Model No.
SFB-CCB3
SFB-CCB7
SFB-CCB10
SFB-CCB15
SFB-CB05
SFB-CB5
SFB-CB10
SFB-CCB3-MU
SFB-CCB7-MU
SFB-CB05-MU
Connector
Connector
Groove
Cable length (m)
3
7
10
15
0.5
5
10
3
7
0.5
Bottom cap cable
(Optional)
Cable
Main body
M2.6 screw
Enclosed with the
bottom cap cable
© Panasonic Industrial Devices SUNX Co., Ltd. 2017