Speed Controller; Stationary Sanding; Cleaning - Westfalia 88 51 25 Original Instruction Manual

Speed Controller

With the speed controller (1) you can adjust the speed. The required rotation
speed depends on the material being processed and the used sanding paper.
It is best selected by a practical test.
Attention: Do not run the belt sander in continuous operation with low speed.
This will overheat the motor.
You can also adjust the speed during operation.

Cleaning

Always disconnect the belt sander from the mains before cleaning!

Clean the machine of sanding dust and other particles after each use,
using a hand-brush or a cloth.

In particular, the ventilation slots in the motor housing must be cleaned
regularly. If these become blocked the motor may overheat.

Do not clean the machine with aggressive detergents or aggressive chem-
icals.
Operation
18