On/Off Switch; Speed Adjusting Dial; Adjusting The Sanding Table Angle - Westfalia 90 00 83 Original Instructions Manual

9. Clean all sanding dust and debris from the face of the plate. NOTE: Any
dust or debris on the plate will prevent the sandpaper from properly
adhering to the plate.
10. Carefully place the glued side of the new sanding disc onto the sanding
plate.
Warning: The new sandpaper MUST be centred and firmly pressed onto the
disc to prevent vibration and the possibility of the sandpaper flying off the plate
when the sander is turned ON. Serious injury could result from flying
sandpaper.

ON/OFF Switch

Speed Adjusting Dial

The speed of the sander can be adjusted to suit
the need. To set the sander speed, rotate the
speed adjusting dial (4). For the fastest speed,
set the speed adjusting dial to #6. For the slowest
speed, set the speed adjusting dial to #1.

Adjusting the Sanding Table Angle

5
5. When the sanding table adjustment knob is loose enough, tilt the table
downward until the desired angle (A) is aligned with the indexing mark (B).
To turn the sander ON, set the ON/OFF switch
3 (3) to I. To turn the sander OFF, set the
ON/OFF switch to O.
The disc sander is intended for operation in the
S2 mode (15 min. operation, 10 min cool-off).
B
A
Operation
The sanding table can be tilted from up-
ward 10° to downward 50°. Set the sanding
table angle as follows:
4. Loosen the bevel angle locking knob (5) by
turning it counter clockwise. Note: If the
adjustment knob does not loosen, hold the
adjustment knob on the opposite side of
the sanding table while loosening adjust-
ment Knob (5).
14
4