Water Supply And Extraction; Circuit Breaker And On/Off Switch; Speed Control; Cleaning And Storing The Polisher - Westfalia 86 39 47 Instruction Manual

Water Supply and Extraction

Use a suitable adapter to attach the water hose to a water supply
e.g. a water tap. The water is spread by nozzles in the middle of
the grinding dish. With the valve (5) you can regulate the water
supply. You can a suitable extraction device e.g. a wet/dry
vaccum, to the flange on the protective hood.
Make sure no water can enter the machine during
work and do not operate the machine under wet
conditions or in rain.

Circuit Breaker and ON/OFF Switch

Before each use test the PRCD with a short test run.
1. Insert the power plug into a grounded wall socket.
2. Push the ON button (9) on the PRCD.
3. Now push the ON/OFF switch forward.
4. To switch off the machine push the switch backward.
5. Push the OFF button on the PRCD.

Speed Control

The speed control dial (8) is located at the back of the machine.

Cleaning and Storing the Polisher

 Use only a moist cloth to clean the housing of the polisher.
 Do not immerse the polisher in water.
 Do not use aggressive chemicals as benzene or thinner,
which may dissolve plastic parts, or abrasives.
 Keep the ventilation openings always clean and free from
obstructions. Clean ventilation openings with a soft paint
brush.
 Store the polisher in a dry place and protect it from dust and
dirt.
Operating
15