Turning On And Off; Regulating The Speed - Westfalia 64 16 05 Original Instruction Manual

3. Tension the sanding belt with the
tensioning lever (8) by turning
back.
4. Start up the power file at the
lowest speed – speed regulator
(2) must be set to position 1 – and adjust the position of the
sanding belt by turning the regulating turn knob (7). Adjust the
sanding belt in such a way that the belt does not walk off the
front pulley to one side.

Turning ON and OFF

1. The power file is turned on with the ON/OFF switch (1). When
the switch is pressed, the power file starts up and runs with the
preset speed on the speed regulator (2).
2. To turn the power file off, release the ON/OFF switch (1). For
continuous use, the switch can be locked in place with the
locking button (9). Press the ON/OFF switch and than press the
locking button. Now the ON/OFF switch is locked and can be
released.
3. To release the locking, first press the ON/OFF switch (1). The
locking button lightly jumps out of the housing and the power file
turns off after releasing the ON/OFF switch.

Regulating the Speed

The speed of the power file can be regulated with
the speed regulator (2) in order to match the
material which is to be machined.
1. Turn the regulator to the position 1 for low
speed (1070 m/min
max. speed (1650 m/min
2. During operation it is also possible to infinitely
adjust the speed with the sped regulator.
Operation
-1
) and to the position 6 for
-1
).
12