Transport; Loading; Unloading The Device - AS MOTOR AS 940 Sherpa 4WD XL Operator's Manual

Transport

Warning
Risk of injury due to the heavy weight of the device. The
device can fall over and fall down and cause severe injur-
ies.
► Observe the following notices.
Transport the device by truck or trailer whose load capacity is
intended for at least the operating weight of the device.
Do not stay in the tilting area of the device.
Prior to each transport, let the device cool down for at least
20 minutes. Close the fuel valve.

Loading

Use suitable ramps for loading that
– support the weight of the device plus 440 lb (200 kg).
– are wider than the device.
– have a slip-free surface.
Notice
Risk of damage due to incorrect fastening of straps.
► Fasten the straps only at the points shown in the figure.
► Do not overtighten the straps.
1. Put the device in front of the ramps and make sure that
the ramps
– are as wide as the wheel gauge of the device.
– are tightly secured to the platform.
– are not steeper than 15°.
2. Carefully drive the device via the ramps onto the plat-
form.
3. Secure the device against rolling, sliding and tilting. Use
straps that support the weight of the device.
Fig. 14:
Fig. 15:

Unloading the device

1. Undo the transport fastenings.
2. Drive the device carefully down the ramps of the platform.
Transport
23