When Work Is Completed; Use Caution During Maintenance And Repair - AS MOTOR AS 940 Sherpa 4WD XL Operator's Manual

When work is completed

After mowing, always close the fuel valve.
Prior to leaving the device, wait until the motor comes to a
standstill and pull off the ignition key.
After switching it off, let the device cool down for at least 20
minutes before you store it in a dry, locked, sufficiently ventil-
ated room.
Never store the device when there is fuel in the tank inside a
building where fuel vapours might come into contact with
open fire or sparks.
Use caution during maintenance and
repair
Only carry out work as described in these operating instruc-
tions. Have an authorised service centre perform all other
work.
Only use the blades and spare parts authorised by "AS-Motor
Germany". Unauthorised blades and spare parts can cause
severe injuries.
Prior to all maintenance work, wait until the engine comes to
a standstill and pull off the ignition key.
We would like to explicitly point out that we cannot be made
responsible for damages caused by our devices if
– worn or damages parts were not repair on time.
– if they were caused by improper repair.
– if, in case of a part replacement, other parts than our ori-
ginal components or components approved by us have
been used.
– repair has not been carried out by an authorised service
centre.
The same applies to spare parts.
Safety instructions
15