Drive/Idle Mode - AS MOTOR AS 940 Sherpa 4WD XL Operator's Manual

Control elements
Ignition lock (4)
The ignition lock has three positions.
OFF: Ignition off.
The key can be removed.
ON: Ignition on.
START: Electric starter on.
Drive lever with parking brake (5)
The drive lever is required for moving the device forward, re-
versing as well as stopping the device. The further you move
the lever in one or the other direction, the faster the device
moves.
In the neutral position, the parking brake is active.
Reversing
Stopping (neutral position/parking
P
brake)
Moving forward
Accelerator lever with choke (6)
With the accelerator lever, you can change the engine
speed and thus control the engine output. When you start
the device when the engine is cold, move the accelerator
lever to choke position (choke is closed).
MIN: Idling speed. Pull the acceler-
ator lever all the way up.
MAX: Full throttle position
Choke: Choke closed (only for en-
gine start when engine is cold).
Press the accelerator lever all the
way down.
Seat springing (7)
The seat springing can be adjusted to the driver's weight.
Heavy driver: Turn clockwise
Light driver: Turn anti-clockwise
18
Operating hours counter (8)
The operating hours are counted as soon as the engine is
running.
Display:
– When engine is running: engine speed
– When engine is off: operating hours

Drive/idle mode

To push the device without engine drive, unlock the drive at
the rear of the device and release the parking break.
2
Fig. 12:
Fig. 13:
1: = Locked
2: = Unlocked (idle speed)
1