Page 1
Operator's Manual Allmäher® AS 62 E-Allmäher, AS 63 E-Allmäher From serial number: AS 62 E-Allmäher: 038222010001, AS 63 E-Allmäher: 038322010001 Issued: 11.02.2022, V1.0 en-Translation of the Original Operator's Manual...
dummy Contact Notes on the operating manual If you have questions about your device, please contact your customer service. Dear customer, For international AS partners, please see: Congratulations on your purchase. You have www.as‑motor.com. acquired a reliable quality product by ”AS-Motor”.
In particular, the device must not be used: Intended use – to cut hard objects, stones, rubble, or pieces The device is intended only for cutting grass or of wood. similar vegetation in well-maintained grounds – to trim bushes, hedges, and shrubbery. in agriculture, forestry and preservation of the countryside that are cut at least once a year.
Contents Driving AS 62 E-Allmäher ...... Notes on the operating manual..... Driving............. 26 Contact ............ Turning............ 26 Device data..........Pushing............ 26 Intended use..........Driving AS 63 E-Allmäher ...... Driving............. 27 Explanation of the symbols....Turning............ 27 Symbols in the instructions...... 6 Pushing............
Page 5
Technical specifications......Accessories..........46 Declaration of conformity......
dummy Inhaltsverzeichnis Explanation of the symbols Warning Hazardous situation Symbols in the instructions Indicates a possibly hazardous situation In these operating instructions, the following with a medium level of risk that, if not symbols are used to denote special dangers. avoided, could result in minor or moderate injury.
Type plate The quickly rotating blades can cause life-threatening injuries or The type plate on the device provides you major property damage! Make with information on the device type and sure to especially keep hands the technical data. and feet away from the blades when the device is in operation.
Safe handling of the battery Safety instructions Observe the information in the operator’s Get informed! manual of the battery. Children cannot recognize the dangers caused For your safety, read these operating instruc- by the battery. tions carefully. Familiarize yourself with the control elements and the proper use of the –...
Page 9
Operationally safe condition A damaged or defective battery may smoke or catch on fire and cause life-threatening injuries The battery is in a safe operating condition or major damage to property. when – If the battery smokes: Do not use the battery –...
Safe handling of the charger – Use the rear wall bracket to hang the char- ger. Observe the operator’s manual of the charger. – Do not unplug the power cord from the wall Children cannot recognize the dangers caused outlet by any means other than the power by the charger.
Risk of injury due to damaged or defective Danger area charger. A damaged or defective charger may smoke and cause injury or damage to property. – Pull the mains plug from the mains socket. During the charging process, the charger may overheat, catch fire and cause life-threatening injuries or major material damage if there is in- sufficient ventilation.
Use caution during operation Prior to mowing Danger of injury during motor start Personal protective measures The motor must not be started, During mowing, always wear – When other persons are in close proximity. safety shoes with good grip and long trousers.
Use caution when mowing Vibrations When the device is used over a longer period Risk of injury of time, vibrations can cause disturbances in Risk of injury caused by ejected objects. Never the blood supply of the hands. A generally ac- mow when persons, children, pets or material cepted usage time cannot be determined.
– Mow only when the ground is dry and has a Use caution during maintenance good grip. and repair – Mow only when the steerable front wheel is Only carry out work as described in these op- locked. erating instructions. Have an authorised ser- vice centre perform all other work.
Vario lever (C) Control elements With the vario lever, you can continuously ad- Handlebar with controls (1) just the speed of the device while the engine is running. MIN: slow MAX: fast Lever blade clutch/engine brake (D) Use the engine blade clutch lever to switch the engine and blade on and off.
Page 17
Lever for height adjustment of Engine status light on the on/off switch (3) handlebar (15) The on/off switch is equipped with an engine The height of the handlebar can be set to 5 po- status light. When the engine is ready for oper- sitions.
Recommendation for the selection Information on mowing of the engine speed Prior to mowing, check the device for com- pleteness, proper function, and cleanliness. A dirty air filter causes overheating of the engine Reduced engine speed for extended battery which can result in engine damage. life and lower emissions.
Checking the battery’s charging Prior to starting status Warning A damaged or defective battery may smoke or catch on fire and cause life-threatening injuries or major damage to property. ► Do not use or charge a damaged or de- fective battery. Press button (A) on the battery.
Changing the battery Status of battery and charger The LEDs on the charger indicate the status: LED 1 LED 2 LED 3 LED 4 Removing the battery scrip- 1. Open the cover of the battery compartment tion (1). Flashing Battery 2. Press the unlock button (2). red or or char- 3.
When the LED 1 flashes red: Changing the backpack battery – Remove the battery from the charger and re- Danger insert the battery into the charger. If LED 1 flashes red again, the battery may be defect- Risk of electric shock due to incorrectly ive.
Inserting the backpack battery LED 1 LED 2 LED 3 Descrip- 1. Push the backpack battery (4) onto the ad- tion apter plate until it audibly locks. Glowing Flashing Battery or 2. Check that the backpack battery (4) is se- green charger curely in place. defective.
When the LED 3 flashes red: Adjusting cutting height – Unplug the charger and plug it back in. The Adjust the cutting height setting only when the charger performs a self-check. If not all engine is switched off. LEDs are lit, the charger is defective and Set the cutting height so that the blade does must be replaced.
Page 24
Rear axle Rear axle AS 62 E-Allmäher AS 63 E-Allmäher The height on the rear axle can be adjusted to The height on the rear axle can be adjusted to 5 positions. 4 positions. 1. Switch off the engine and wait until the en- 1.
Locking steerable front wheel Starting It is more comfortable on an even surface to let Danger the front wheels swivel. If you move crossways to the slope, make sure the wheels are locked. Danger of electric shock from live cables on the mowing area.
Turning Driving AS 62 E-Allmäher Turn the device round only where the grass Warning has been mowed already. Risk of injury caused by tripping or sliding Turning round on an even surface: while pushing the mower, moving it back- 1. Switch off the drive. wards and turning it round.
Turning Driving AS 63 E-Allmäher Turn the device around only in already mown Warning sections. Risk of injury caused by tripping or sliding Turning on a level surface: while pushing the mower, moving it back- 1. Switch off the drive. wards and turning it round.
Switching off and parking Transport Warning Warning On a slope, the device can roll away. Risk of injury due to the heavy weight of the device. The device can fall over and fall ► Put the device on even ground only or down and cause severe injuries.
Transport position 1 Transport position 2 1. Release the steerable front wheel interlock (4) on both front wheels. 2. Pull off the pin cotter (2) on the crank (1) for the height adjustment. 3. Fold the crank (1) fully up for height adjust- ment.
Loading Use suitable ramps for loading that – can carry the empty weight of the device + 200 kg. – are wider than the device. – have a slip-free surface. Notice Risk of damage due to incorrect fastening of straps. ►...
Transporting the battery The battery is subject to the legal regulations for dangerous goods. For commercial trans- port, special requirements must be met and all applicable local and state laws must be com- plied with. Always store and transport a damaged or de- fective battery in such a way that smoke or fire cannot endanger people or cause damage to property.
Improper maintenance can make the device Maintenance unsafe for operation and result in accidents. Regular maintenance keeps your device ready Warning for use. Risk of injury from electric shock on live Service the device according to the following parts. maintenance instructions. ►...
Maintenance overview Component Action Maintenance interval Device Check for safe working condition (basic inspection). ■ ▲ Clean. ■ Customer service. ▲ Batteries and char- Check batteries and chargers. ■ ▲ gers Check battery status,. Charge batteries. ■ ▲ Air filter Maintain.
Page 34
Tyres Check tyres and, if necessary, the tyre pressure. ■ ▲ Lubrication See chapter grease lubrication. ■ ▲■ Before and after each use. Annually or every 50 h. ■ By the user when the engine is not running. □ By the user when the engine is running. ▲...
Cleaning position Cleaning the device Beware: The cleaning position can only be Depending on use, clean the device thor- used when the backpack battery is not inserted oughly, especially the bottom and the blade. on the adapter plate. Grass build-up and dirt that are stuck interfere with the grass ejection and impair the cutting quality.
Maintaining the engine Checking the battery and the charger The engine manufacturer has prepared an op- erating manual for the engine. The manual Warning contains all mandatory maintenance require- ments and warranty conditions for the engine. A damaged or defective battery may smoke If warranty work at the engine is required, con- or catch on fire and cause life-threatening tact your authorised service centre.
Additional inspection for backpack battery Checking the parking brake Check that the backpack battery engages cor- AS 63 E-Allmäher rectly on the adapter plate when inserted. Check that the plug of the backpack battery Warning can be fully inserted into the connection socket If the parking brake is incorrectly adjusted, on the engine and is securely held in place.
Grease lubrication All shown blade parts and their fastening ele- ments must be changed The cutting height setting at the front axle is – if damage or cracks are detected. shown by a lubricating nipple. – if unusually strong vibrations occur. 1.
Original blade Assembly An original AS-blade is engraved with: Scope of delivery AS XXXXXXXX The engraving shows the spare part number. The device is shipped in a carton. The scope of delivery includes: Checking the blade clutch – The device. Check the blade clutch for proper function by disengaging the blade.
6. Fold the rollbar (5) fully down. Unfolding the device 7. Fold the crank for height adjustment (1) for- ward. 8. Lock the crank for the height adjustment with the spring cotter (2) on the rollbar. Fig. 14: 1. Pull off the pin cotter (2) between guide rail and crank of the height adjustment(1).
Automatic self-maintenance of the battery Storage The battery has an automatic self-maintenance function to prolong its service life. Warning When 5 LEDs alternately light up red for 10 A damaged or defective battery may smoke seconds and are off for 10 seconds or 5 LEDs or catch on fire and cause life-threatening flash green every 2 seconds, the battery is per- injuries or major damage to property.
Spare parts Disposal The reliable and safe operation of the device The device cuts and shreds the growth in a also depends on the quality of the spare parts single operation. Shredded plant material de- used. Only use original spare parts and ac- composes quickly and can be used as fertilizer cessories approved by “AS-Motor.”...
Troubleshooting The following table contains the most frequent problems and their elimination. If more problems occur, contact the closest authorised service centre. You can find an authorised service centre on our home page www.as-motor.com. Problem Possible cause Remedy Engine does not turn Battery is not inserted correctly. Remove battery and insert correctly. Engine is not ready for opera- Switch the engine to standby.
Page 44
Strong vibrations dur- Imbalance of the blade caused Have blade resharpened and balanced ing operation by incorrect sharpening or by an authorised service centre. Re- chips on the blade. place a damaged blade immediately. Blade drive shaft is bent due to Authorised service centre.
Page 45
Technical specifications Type AS 62 E-Allmäher AS 63 E-Allmäher Range of application (temperature) 5 - 30 °C Observe the information of the engine manufacturer. Engine Type Electric engine Manufacturer EGO Power Plus Type PU2700S Maximum engine performance 3,47 kW Speed Eco 2800 min Speed turbo 3000 min Voltage...
Page 47
Declaration of conformity AS-Motor GmbH Ellwanger Straße 15 D-74424 Bühlertann www.as-motor.com Declaration of conformity We declare that the grassland mowers Type AS 62 E-Allmäher AS 63 E-Allmäher starting from serial no. 038222010001 038322010001 as brought into circulation by us conform to all relevant safety and - 2006/42/EC health requirements of the EC directives listed.
Page 48
AS-Motor GmbH Ellwanger Straße 15 D-74424 Bühlertann www.as-motor.com AS-Motor is your premium manufacturer for lawn and high grass mowers as well as weed re- movers. We offer our customers professional technology for steep slopes, rough terrain, and lawn care. Our extensive product range which includes hand-held entry-level devices up to devices with remote control will always offer private customers, service providers, cities, municipalities and road maintenance authorities the right product.
Need help?
Do you have a question about the AS 62 E-Allmaher and is the answer not in the manual?
Questions and answers