When Work Is Completed; Use Caution During Maintenance And Repair - AS MOTOR AS 420 E-ProClip Operator's Manual

Hide thumbs Also See for AS 420 E-ProClip:
Table of Contents

Advertisement

If the device tilts or slips
– Never try to stop a tilting or sliding device.
Severe injuries can result.
– Remove leaking fluids (oil, fuel, battery acid)
from the device and the floor. Deposit of
contaminated soil environment friendly ac-
cording to the local regulation.
– Undetectable damage may have occurred to
the device. In case of malfunctions, there is
a risk of injury. Have an authorised service
centre check the device.

When work is completed

Prior to leaving the device, wait until the engine
stops and remove all batteries
– to prevent unauthorised use.
– to prevent accidental starting.
After switching it off, let the device cool down
for at least 20 minutes before you store it in a
dry, closed, sufficiently ventilated room.
Use caution during maintenance
and repair
Only carry out work as described in these op-
erating instructions. Have an authorised ser-
vice centre perform all other work.
Only use blades and spare parts approved by
"AS-Motor". Unauthorized blades and spare
parts can cause severe injuries.
Prior to all maintenance work, wait until the en-
gine stops and remove all batteries.
We explicitly point out that, in accordance with
the Product Liability Act, we are not liable for
damages that were caused by our devices if
– worn or damaged parts were not repaired or
replaced on time.
– these damages were caused by improper
repair.
– when changing a part, our original parts or
parts authorised by us were not used.
– the repair work was not carried out by an au-
thorised service station.
The same applies for spare parts and
accessories.
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

As 470 e-proclip a

Table of Contents