Table of Contents
Advertisement
2.5
Setting the FTP Client (Setting the Auto Transfer
of Measurement and Alarm Data Files)
2-8
By setting this function, the measurement and alarm data files created in the internal
memory of the XL100 or an external storage medium can be automatically transferred
using FTP at the time the files are created. To use this function, however, the Ethernet
interface must be configured as described in section 2.3.
• Selecting the Transferred Files
• You can select whether to automatically transfer the measurement and alarm data
files. The default setting is OFF.
• The data files are automatically transferred to the FTP destination explained in the
next section at the end of the logging operation.
Note
If a file with the same name is detected at the destination, the file is transferred with the
last character of the file name changed.
Example: If the file to be transferred named "050714130440.DLO" exists at the
destination, the file name is changed to "050714130440Fxxxx.DLO" (where
xxxx is a value between 0000 and 9999) before it is transferred.
• Setting the FTP Destination
Consult your system or network administrator when setting parameters such as the
primary/secondary FTP servers, port number, login name, password, account, and
availability of the PASV mode.
• Specifying Primary and Secondary
You can specify two destination FTP servers, primary and secondary. If the primary
server is down, the file is transferred to the secondary server.
• FTP Server Name
Enter the name of the file transfer destination FTP server using up to 64
alphanumeric characters.
• If the DNS is used, you can set the host name as a server name.
For details on setting the DNS, see section 2.3, "Setting the Ethernet Interface."
• You can also set the IP address. In this case, the DNS is not required.
• Port Number
Enter the port number of the file transfer destination FTP server in the range of 1 to
65535. The initial value is 21.
• Login Name
Enter the login name for accessing the FTP server using up to 32 alphanumeric
characters.
• Password
Enter the password for accessing the FTP server using up to 32 alphanumeric
characters.
• PASV Mode
Turn PASV mode ON when using the XL100 behind a firewall that requires the
passive mode. The default setting is OFF. A firewall is furnished on a router (or a
similar device) that has security features. It prevents intrusion from the outside into
the network system.
IM XL100C-E
Advertisement
Table of Contents
