Table of Contents
Advertisement
2.3
Configuring of the Ethernet Interface
Selecting the Communication Interface
Setting the Ethernet Parameters
IM XL100C-E
The following configurations must be made to use the Ethernet communication functions
of the XL100.
Communication can only be performed on a single interface at any given time. You must
select the communication interface by carrying out the steps below. The default setting is
LAN (Ethernet).
Procedure
1.
Press SETTING to enter Setting Mode.
2.
Use the arrow keys to select COMMUNICATION, and press SELECT.
3.
With INTERFACE selected, press SELECT.
An interface selection list is displayed.
4.
Use the arrow keys to select a communication interface, and press SELECT.
5.
Press SET.
• Setting the Time Zone
Set the time difference from Greenwich Mean Time.
• Setting the DHCP, IP Address, Subnet Mask, Default Gateway, and DNS
Consult your system or network administrator when setting parameters such as the IP
address, subnet mask, default gateway, and DNS (domain name system).
• DHCP (Dynamic Host Configuration Protocol)
• The IP address, subnet mask, default gateway, and DNS can be automatically
set by using DHCP.
• To use DHCP, the network must have a DHCP server.
• Consult your network administrator to see if DHCP can be used.
• If you use DHCP, a different IP address may be assigned each time the XL100
is powered up. You must pay attention when using the FTP server function of
the XL100.
→
1
2
3
4
5
6
7
App
Index
2-3
Advertisement
Table of Contents
