Tenma 72-7615 Manual page 25

Recording
Menu
Record
Cancel
n (F3)
u
(F4)
l
(F5)
PASS TEST
• The pass (fail) test is by using a template to detect whether the input signal satisfies
the template requirements.
Function Introduction
• Press UTILITY button then F5 to enter the secondary menu then press F2 to enter
the test menu.
Functions
Allow test
Output
Source
Display info
Next Page
Functions
Operation
Stop setting
Template setting
Back
• After opening the pass test, you are required to set the stop settings and template
settings before you can perform the test function. Otherwise you'll be prompted
"Function is Disabled".
Setup
CH1 Select CH1 as the recording signal source
CH2 Select CH2 as the recording signal source
Quit the current record menu and return to previous menu
Stop recording
Playback button - the system plays back and displays the
position reference in the lower RH corner. Use the multi-
function control to select the waveform to be displayed
repeatedly.
Record button - use to record. The position reference is
displayed in the bottom of the screen
Options
Close Close Pass Test
Open Open Pass Test
Set the Pass/Fail interface on the rear panel to a "failure"
Fail
pulse and sound a buzzer
Set the Pass/Fail interface on the rear panel to a "pass"
Pass
pulse and sound a buzzer
CH1 to CH4 Set the source channel for the Pass Test
Close Turn off the display information
Open Turn on the display information
Enter Pass Test menu (2)
Options
Close Disable Pass Test
Open Enable Pass Test
Enters Stop Settings Menu
CH1 to CH4 Enters Template Settings Menu
Back to Pass Test menu
Notes
Description
Description
25