Phone Line Or Connections; Sending Faxes - Brother IntelliFAX 1270E Owner's Manual

Phone Line or Connections

Fax Machine Does Not Answer When Called
Make sure the fax machine is in the correct receiving mode for your setup
(either FAX ONLY
fax machine to hear it answer. If there is still no answer, check the telephone
line cord connection.
(See
Connecting the Machine
Connect a standard telephone handset to the fax machine's telephone jack. If
there is no ringing when you call your fax machine, call your telephone
company to check the line.
Telephone Answering Device (TAD) Does Not Answer When Called
Connect the telephone line cord from your TAD to the back of the fax machine,
in the jack labeled EXT. Make sure the TAD is set to answer calls.
(See
Connecting an External Telephone Answering Device (TAD)
No Dial Tone on the Handset
Press Hook—OR—Lift the handset. If you don't hear a dial tone, check
telephone line cord connections at the fax machine and wall jack. Check that the
handset is connected to the fax machine's handset jack. Test the wall jack with
another single line telephone. If there is no dial tone at the wall outlet, call your
telephone company.
The Caller ID Does Not Display after the Call Waiting Signal
The Caller ID signal is sent ten seconds after the Call Waiting Signal and
speaking may interfere with it. When you hear the Call Waiting signal, ask the
other party to hold while you answer the call. Then stop speaking until you see
the Caller ID on the LCD.

Sending Faxes

Poor Transmitting Quality
Try changing your resolution to FINE or S. FINE. (See
Make a copy to verify the fax machine's scanner operation.
Dialing Does Not Work
Check all line cord connections, and make sure the curled handset cord is not in
the EXT jack.
Check power cord connection.
Send a manual fax by pressing Hook or by lifting the handset and dialing the
number. Wait to hear fax receiving tones before pressing Fax Start.
Vertical Black Lines When Sending
Use your fax machine to make a copy. If the copy shows the same problem, the
scanner area is dirty. Lift the top cover and check the original path. Clean the
scanner's white roller and the glass strip under the roller using isopropyl alcohol
and a lint-free cloth. (See
T R O U B L E S H O O T I N G A N D R O U T I N E M A I N T E N A N C E
or FAX/TEL). Check for a dial tone. If possible, call your
, page 2-5 and Connect the telephone line.)
Cleaning the Scanner
, page 2-9.)
, page 6-6.)
Resolution
, page 13-9.)
13 - 7