Changing The Remote Retrieval Access Code; Remote Retrieval; Using Remote Retrieval Access Code - Brother IntelliFAX 1270E Owner's Manual

Changing the Remote Retrieval Access Code

Enter your Remote Access Code when the machine picks up your call, so you
can access features remotely. The access code is preset to 1 5 9
change this. (See
1
Press Menu/Set, 8, 3.
2
Enter a three-digit number from 000 to
999, and then press Menu/Set. The " " cannot be changed. (Do not use the
same digits that appear in your Fax Receive Code or Telephone Answer Code.)
3
Press Stop/Exit.

Remote Retrieval

You can call your machine from any fax machine using touch tone, then use the
Remote Retrieval Access Code and other button presses to retrieve fax
messages. Cut out the Remote Retrieval Access Card on the last page and keep
it in your wallet as an aid.

Using Remote Retrieval Access Code

1
Dial your fax number from a fax machine using touch tone.
2
When your machine answers, immediately enter your Remote Retrieval Access
Code (1 5 9
3
The machine signals the kinds of messages received:
1 long beep — Fax message(s)
No beeps — No messages
4
The machine then prompts you with two short beeps to enter a command. If you
wait longer than 30 seconds to enter a command, the machine hangs up. If you
enter an invalid command, the machine beeps three times.
5
Press 9 0 to reset the machine when you're finished.
6
Hang up.
If your machine is set to
Note
2 minutes, and then entering the Remote Retrieval Access Code within 30
seconds.
9 - 3
R E M O T E F A X O P T I O N S
Operation from External or Extension Telephone
).
MANUAL mode, you can access it by waiting about
, but you can
, page 5-6.)