Sartorius PMA.Power Operating Instructions Manual page 7

Connecting to AC Power
The equipment is powered through the scale's power
cord� Make sure that the voltage rating printed on
this unit is identical to your local line voltage�
If the stated supply voltage or the plug design of the
power cord does not comply with the standard you
use, please inform your nearest Sartorius representa-
tive or your supplier�
Installation
The device must be plugged into a properly installed
wall outlet which has a protective grounding
conductor (PE) and a max� (16A) fuse�
§ Connection of the power cord plug (12) outside of
the hazardous area or mechanically secured (refer to
"Safety Information" documents)�
§ Plug the power cord into a wall outlet (mains)�
Observe all warnings and safety precautions�
See also: "Safety Instructions" documents� Install
!
the scale in such a way or protect the power cord in
such a way that mechanical tensile load on the plug
and cable gland (on the scale) is prevented!
Note:
When installing the scale in a Zone 2 hazardous
area, connectors may only be plugged in or discon-
nected in a currentless/dead-voltage state�
Disconnect the scale from the power line before
connecting peripheral devices (printer, PC) to the
data interface of the device�
§ When connecting peripheral devices (printer, PC) to
the scale's data interface, make sure that the screws
on the data plug are tightened securely�
Observe all warnings and safety precautions�
!
See also: "Safety Instructions" documents�
7