Making Copies; Using The Mfc As A Copier; Enter Copy Mode; Making A Single Copy - Brother MFC-7420 User Manual

'
8

Making copies

Using the MFC as a
copier
You can use your MFC as a copier, making
up to 99 copies at a time.

Enter Copy mode

Before making copies, make sure that
(Copy) is illuminated in green. If it is
not, press (Copy) to enter Copy mode.
The default setting is Fax mode. You can
change the number of seconds or minutes
that the MFC stays in Copy mode. (See
Setting the Mode Timer on page 2-3.)
The LCD shows the default copy setting
Stack Copies:01
100%
Stack/Sort
Copy Ratio
Contrast
8 - 1
Auto
No. of Copies
Quality
The printable area of your MFC begins at
approximately 0.12 in. (3 mm) from both
sides and 0.12 in. (3 mm) from the top or
bottom of the paper.
0.12" (3 mm)
0.12" (3 mm)
Note
This printable area shown above is for a
single copy or a 1 in 1 copy using Letter or
Legal size paper. The printable area changes
with the paper size.

Making a single copy

1
Press (Copy) to illuminate it in
green.
2
Load your document.
(See Load document on page 1-7.)
3
Press Start.
Note
To stop copying, press Stop/Exit.
Unprintable
area