Accessing Control Panel Menu - Miller Dynasty 210 DX CPS Owner's Manual

7-2.

Accessing Control Panel Menu

2
OM-270536 Page 40
.
A complete Parts List is available at www.MillerWelds.com
3
4
150A
Polarity Selection
Select output type AC or DC. With DC selected, the electrode will be negative (DCEN) for TIG, and
positive (DCEP) for Stick.
Process Selection
TIG HF Impulse − is a non-contact arc starting method for AC and DC TIG welding (see Section 17-1).
TIG Lift-Arc − Is a contact arc starting method for AC and DC TIG welding (see Section 17-1).
Stick − Select AC or DC Stick (SMAW) welding.
Trigger Mode Selection (See Section 11-4 for additional trigger function options).
[RMT] [STD]
Typical setting for a remote foot or hand control. RMT STD requires a maintained contact closure to
enable weld output. Amperage can be controlled with a remote potentiometer, or it can be set at the
control panel.
[RMT] 2T [HOLD] (TIG Only)
Remote control required. Allows the operator to weld without holding the trigger closed. To start the
weld, operator presses and releases trigger. To stop the weld, the operator again presses and re-
leases the trigger. In this mode, only the output contactor is controlled by the remote control. Amper-
age must be set on the control panel. (see Section 11-4).
[OUT] [ON]
Output on. (Stick and TIG Lift Only)
!
Weld output terminals are energized at all times when displays read [OUT] [ON].
No remote control or trigger required. Amperage can be controlled at the control panel or with a remote
potentiometer. Blue output on LED illuminates to indicate output is on.
1 Amperage Button
2 Parameter Display
3 Setting Display
4 Amperage Adjustment Control
Rotate amperage adjustment con-
trol to adjust parameter setting.
1
Amperage Control
Controls the welding amperage out-
put. Limits the maximum output of a
remote amperage device.
150A
247220-D