Table of Contents
Advertisement
Available languages
Available languages
V1.0
2.
Do not use the tool if any parts are damage broken or misplaced.
Repair or replace the parts.
3.
Do not use any power tool with a malfunctioning power switch or
control. A power tool that fails to respond to the controls is dangerous
and can cause an injury. A qualified technician must repair and verify
the power tool is operating correctly before it can be used.
4.
Never use a tool with a cracked or worn tool accessory. Change the
tool accessory before using it.
5.
Do not cover the air vents.
6.
Only use accessories that are specifically designed for use with the
tool. Ensure the accessory is tightly installed.
7.
Only use an accessory that exceeds the speed rating (see Specifications).
8.
Disconnect the power source before installing or servicing the tool.
9.
Remove adjusting keys and wrenches before using the tool. The tool may
eject an attached wrench or a key and cause an injury to you or a bystander.
10. Before using the tool on a workpiece, test the tool by running it at the
highest speed rating for at least 30 seconds in a safe position. Stop
immediately if there is any abnormal vibration or wobbling. Check the
tool to determine the cause.
11.
Never force the tool. Excessive pressure could break the tool, resulting
in damage to your workpiece or serious personal injury. Excessive
pressure is the cause if your tool runs smoothly under no load, but
roughly under load.
12. Keep hands and fingers away from the work area. Any part of the body
contacting the tool's working parts could result in an injury.
13. Never touch the tool accessory or workpiece during or immediately after
use. They may be hot and could inflict a burn injury.
AIR TOOL PRECAUTIONS
1.
Use only clean and dry compressed air as a power source.
Contaminated or moist air will gradually damage the tool.
2.
Install an in-line shutoff valve or regulator to allow immediate control
over the air supply in an emergency, even if a hose is ruptured.
3.
Discontinue tool use if it does not work properly or air is leaking. Tag
or mark the tool as 'defective' or 'out of service' until repaired.
Visit www.princessauto.com for more information
5/16 in. Straight Grip Air Punch and Flange Tool
8843773
5
Advertisement
Table of Contents
