Table of Contents
Advertisement
Username/Password
The Username/Password selection on the Device Settings page (see
page 48) opens a read-only pane that shows the credentials of the decoder (see figure 58).
The Password can be edited by clicking the Edit button (
selection opens (see figure 59).
NOTES:
•
Editing of these settings is disabled and the Edit button is unavailable for selection
when the decoder is assigned to a NAVigator.
•
Any devices assigned to the NAVigator inherit the password of that NAVigator.
1 1 1 1
1 1 1 1 1 1
1 1 1 1
1 1 1 1
Figure 58.
Username/Password Selection
1 1 1 1
1 1 1 1 1 1 1 1
1 1 1 1 1 1
1 1 1 1
1 1 1 1 1 1 1 1
1 1 1 1 1 1
2 2 2 2 2 2 2 2
2 2 2 2
2 2 2 2 2 2
A A A A
A A A A A A
A A A A A A A A
Figure 59.
Editable Username/Password Selection
Password and Confirm Password — Click in these fields and type in a valid
1
password values to enter the appropriate connection values for your decoder.
NOTES:
•
A valid password meets the following requirements:
•
The length is up to 64 characters.
•
All alphanumeric characters and ASCII symbols are permitted except |
(pipe).
•
The password cannot be blank.
•
The password cannot start with a space.
•
The factory configured passwords for all accounts on this device have been
set to the device serial number. In the event of a complete system reset, the
passwords revert to the default.
•
The default username is
TIP:
Select (click) the Show Password checkbox (
you type it.
Save and Cancel buttons — Click Save to take Password change or Cancel to
2
abandon it. Clicking either button closes the editable selection.
NAV SD 501 and NAV SD 101 Scaling Decoders • HTML Operation
). An editable version of the
1
and the default password is
admin
) to display the password as
A
figure 47
on
.
extron
55
Advertisement
Table of Contents
