Table of Contents
Advertisement
A
NAV 1G/PoE+ port
(see
Ethernet LAN on which one or more encoders also reside for
streaming, control, and PoE+.
NOTES:
•
See
TP cable termination
RJ-45 connectors
•
The Extension port (
•
RJ-45 port LEDs for both ports indicate as follows:
•
Act (amber) LED — Indicates transmission of data packets on the RJ-45
connector. This LED blinks as the decoder communicates.
•
Link (green) LED — Indicates that the decoder is properly connected to
an Ethernet LAN. This LED lights steadily.
B
HDMI output port
— Connect an HDMI cable between this port and
an HDMI display. See
LockIt Lacing Brackets
HDMI Cable Lacing Bracket to secure the connector to the decoder.
C
Audio output port
— This 5-pole, 3.5 mm captive screw connector
outputs the streamed, unamplified, line level analog audio. Connect an
audio device, such as an audio amplifier or powered speakers (see
Analog audio connector
D
Control (RS-232/IR port
IR signal, or both to this 3.5 mm, 5-pole captive screw connector for
bidirectional RS-232 and IR communication (see
wiring
on page 9 to wire the connector).
E
USB 2.0 port
(NAV SD 501 only) — Connect a USB Type-C cable from a
USB host or a USB device. See
USB connector to the decoder.
NOTE: This connector is limited to supplying 500 mA in USB device mode.
F
Extension port
(NAV SD 501 only) — If desired, connect another
networked device to this port. The port acts as a networked switch to the
NAV 1G/PoE+ port (
A
Reset button and LED
G
decoder reset. For the different reset levels, press and hold the button while the
decoder is running or while you power up the decoder (see
on page 15 for details).
Power connector
— Plug the included external 12 VDC power supply into this
H
2-pole connector.
NOTE: Alternatively, the decoder can be powered via PoE+.
ATTENTION:
•
Do not connect power to the decoder until you have read the
ATTENTION
notices on pages 10 and 11.
•
Ne connectez pas l'alimentation à l'encodeur avant d'avoir lu les rubriques
«
ATTENTION
NAV SD 501 and NAV SD 101 Scaling Decoders • Installation
figure 2
on page 5) — Connect to an
on page 7 to properly wire the
A
and
F
.
F
) cannot provide PoE.
on page 8 to use the LockIt
on page 9 to wire the connector).
— Connect a serial RS-232 signal, a modulated
Control connector
LockIt Lacing Brackets
).
— The Reset button initiates three levels of
» des pages 10 et 11.
NAV 1G/PoE+
HDMI
AUDIO
L
RS-232
Tx Rx G S G
USB 2.0
to securely fasten the
5V/500 mA
EXT
RESET
Reset Operations
POWER
12V
2.0 A MAX
CAUTION
and
R
IR
6
Advertisement
Table of Contents
