INSTALLATION INSTRUCTIONS
Changing the PROCESSOR Setup Options
ESD
Possible damage from electrostatic discharge.
[1] Pull out the SUPPORT SHELF for the ELECTRICAL BOX from the drive side of the PROCESSOR.
[2] Pull out the ELECTRICAL BOX.
[3] Connect your ESD protective wrist strap to the ESD JACK on the ELECTRICAL BOX.
[4] Open the COVER of the ELECTRICAL BOX. Fasten the COVER open by placing the O-RING, that is on the
PROCESSOR TANK, around the POST on the COVER.
Pulling Out the ELECTRICAL BOX
Figure 30
O-RING
POST
COVER
ELECTRICAL
BOX
ELECTRICAL
BOX
SUPPORT SHELF
36
ESD
JACK
100 CIRCUIT BOARD
H130_0143HCA
H130_0143HA
September 1995 – 981088