Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Installing the FIXER and DEVELOPER RACKS
[1] Manually turn the DRIVE GEAR on the FIXER and DEVELOPER RACKS. Check that all ROLLERS turn
easily.
[2] Check both the FIXER and DEVELOPER RACKS for squareness by placing them on a flat work surface. If
the RACK does not sit flat on the work surface:
a. Loosen the 8 TIE ROD SCREWS.
b. Press down on the RACK until it sits flat on the work surface.
c. Tighten the TIE ROD SCREWS.
[3] Install the FIXER RACK into the FIXER TANK. Install the DEVELOPER RACK into the DEVELOPER
TANK.
• The FIXER RACK and DEVELOPER RACK have different colored WIRE TIES for easy identification:
– The FIXER RACK has a blue WIRE TIE.
– The DEVELOPER RACK has a red WIRE TIE.
• Install the FIXER RACK so that the blue WIRE TIE is on the drive side of the FIXER TANK.
• Install the DEVELOPER RACK so that the red WIRE TIE is on the drive side of the DEVELOPER TANK.
[4] Check that the DRIVE GEARS on the RACKS correctly engage with the GEARS on the MAIN DRIVE
SHAFT.
Installing the FIXER RACK
Figure 37
DRIVE GEAR
MAIN DRIVE SHAFT
DRIVE GEAR
44
blue WIRE TIE
EVAPORATION COVER
FIXER RACK
H130_0135HCB
H130_0135HA
September 1995 – 981088
Advertisement
Table of Contents
