Am Subsystem - Fluke 9640A Series Instruction Manual

9640A
Instruction Manual

AM Subsystem

[:SOURce]:AM
[:SOUR]:AM:STATe[?]
[:SOUR]:AM[:DEPTh][?]
[:SOUR]:AM:DEPTh:OFFSet[?]
[:SOUR]:AM:DEPTh:OFFS:STATe [?]
[:SOUR]:AM:DEPTh:OFFS:APPLy [?]
[:SOUR]:AM:DEPTh:OFFS:ERRor[?]
[:SOUR]:AM:INTernal:FREQuency[?]
[:SOUR]:AM:INT:FREQ:OFFSet[?]
[:SOUR]:AM:INT:FREQ:OFFS:STATe[?]
[:SOUR]:AM:INT:FREQ:OFFS:APPLy[?]
[:SOUR]:AM:INT:FREQ:OFFS:ERRor[?]
[:SOUR]:AM:SHAPe[?]
[:SOUR]:AM:COUPling[?]
[:SOUR]:AM:EXTernal :TRIGger[?]
4C-10
Keyword
Parameter *RST
Form Condition
<bool> OFF
<NRf> 0.1 %
<NRf> 0.0 %
<bool> OFF
<bool> OFF
<NRf> 0.0 %
<NRf> 500 Hz
<NRf> 0.0 Hz
<bool> OFF
<bool> OFF
<NRf> 0.0 %
<name>
{SINE |
SINE
TRIangle |
EXTernal}
<name>
AC
{AC| DC}
<name>{
DISable |
DISable
RISing |
FALLing}
Notes
Command long form
This command node is only
available when the AM instrument
is selected.
This selects whether the output
signal has an AM component
This selects the depth of the AM
for the AM instrument
This value is added to the depth
of the output value. Changes to
this value will be reflected in the
AM:OFFSet:ERRor value
This selects whether the offset
mode is present
This selects whether the offset
value is added to the output
depth.
Note: The offset state must be on
for this command to operate
Adjusts the output depth by
setting the offset as an error
rather than an absolute.
This selects the modulation
frequency of the AM
This value is added to the
modulation frequency of the
output value. Changes to this
value will be reflected in the
AM:INT:FREQ:OFFSet:ERRor
value
This selects whether the offset
mode is present
This selects whether the offset
value is added to the output
modulation frequency.
Note: The offset state must be on
for this command to operate
Adjusts the output modulation
frequency by setting the offset as
an error rather than an absolute.
This selects the shape of the
modulation of the AM.
This selects the type of coupling
for the AM.
Selects the type of external
trigger for AM