Frequency Subsystem - Fluke 9640A Series Instruction Manual

FREQuency Subsystem

Keyword
[:SOURce]:FREQuency
[:SOUR]:FREQ:[CW|FIXed][?]
[:SOUR]:FREQ:OFFSet[?]
[:SOUR]:FREQ:OFFS:STATe[?]
[:SOUR]:FREQ:OFFS:APPLy[?]
[:SOUR]:FREQ:OFFS:ERRor[?]
[:SOUR]:FREQ:CENTer[?]
[:SOUR]:FREQ:SPAN[?]
[:SOUR]:FREQ:STARt[?]
[:SOUR]:FREQ:STOP[?]
Parameter *RST
Form Condition
<NRf> 1.0MHz
<NRf> 0.0 Hz
<bool> OFF
<bool> OFF
<NRf> 0.0 %
<NRf> 1.0MHz
<NRf> 9.0 MHz
<NRf> 1.0MHz
<NRf> 10.0MHz
SCPI Commands
SCPI Command Reference
Notes
Command long form
Command not available in the sweep
instrument.
This selects the frequency of the
output for the current instrument that
is selected.
Command not available in the sweep
instrument.
This value is added to the output
value.
Command not available in the sweep
instrument.
This selects whether the offset mode
is present
Command not available in the sweep
instrument.
This selects whether the offset value
is added to the output frequency.
Note: The offset state must be on for
this command to operate
Command not available in the sweep
instrument.
Adjusts the output by setting the
offset as an error rather than an
absolute.
Command only available in the sweep
instrument.
Sets the center frequency for a
frequency sweep.
Command only available in the sweep
instrument.
Sets the span for a frequency sweep.
Command only available in the sweep
instrument.
Sets the start center frequency for a
frequency sweep.
Command only available in the sweep
instrument.
Sets the stop center frequency for a
frequency sweep.
4C
4C-9