Fluke 9640A Series Instruction Manual page 97

Table 3-17. Frequency-Modulation Fields (cont.)
Mod Rate 1 Hz to 300 kHz
Rate Step
0.1 Hz to 300 kHz
Rate Offset
Absolute
either polarity to the full
dynamic range of the parent
parameter
As UUT Error
permitted Offset value
subject to limitations of % or
ppm if these units are used
(see below)
Deviation
.010 kHz to 4.8000 MHz
Dev ≤300 kHz
Dev ≤750 kHz
Dev ≤0.12% Frequency
Step Size
0.1 Hz to 4.8000 MHz
Deviation Offset
Absolute
either polarity to the full
dynamic range of the parent
parameter
As UUT Error
permitted Offset value
subject to limitations of % or
ppm if these units are used
(see below)
* Any entry expressed in % (or converted to %) is subject to a limit of +/-1000%.
** Any entry expressed in ppm (or converted to ppm) is subject to a limit of +/-10000ppm
Offset may be applied in
Will be calculated for any
9 MHz to 31.4375 MHz
>31.4375 to 125.75 MHz
>125.75 MHz
Offset may be applied in
Will be calculated for any
Operating the Instrument
Hz (kHz)
Hz (Hz, kHz)
Hz (kHz), ppm**, %*
ppm**, %**
Hz (Hz, kHz, MHz)
Hz (Hz, kHz, MHz)
Hz (kHz, MHz), ppm**, %*
ppm**, %**
Local Operation 3
3-49