Intel ISP1100 Installation Manual page 3

Scsi cable option kit for internet server

Hide thumbs Also See for ISP1100:

Introduction

This document explains how to install the SCSI cable kit, which is used with third-

party SCSI adapters in the Intel ISP1100 Internet Server. It assumes the system is

configured for IDE and contains either a 3.5" floppy drive or a slimline CD-ROM/

floppy drive assembly. Please ignore steps that do not apply to your system.

Note: You cannot mix IDE and SCSI hard drives inside the server. The hard drives

must be the same type.

Before you begin:

Make sure you have one (1) pre-folded SCSI cable.

Make sure you have the following tools:

• A phillips (cross-head) screwdriver, number 2 bit

• An antistatic wrist strap and conductive foam pad (recommended)

Read the safety and warnings information in the Intel

Quick Start Guide.

Make sure the server is turned off and is not plugged in to an electrical

outlet.

Intel ISP1100 Internet Server SCSI Cable Kit

ISP1100 Internet Server