Install the SCSI Hard Drive(s)
1.
Install the hard drive in the left bay first.
• Holding the drive above the bay, connect the SCSI data cable (A) to the drive.
• Place the drive in the bay so the end of the bracket with the tabs (B) is facing
the server front panel, then gently guide the bracket tabs into the mating slots
in the server front panel.
• Align the two holes in the bottom of the bracket with the two chassis snaptop
standoffs (C).
• Make sure the SCSI cable underneath the bracket isn't caught between the
right bracket hole and the right snaptop standoff.
• Press down the bracket until it snaps onto the snaptop standoffs.
• Connect the power cable (D) to the drive.
12
Intel ISP1100 Internet Server SCSI Cable Kit