SoftBank Whiz Support Manual page 3

Maintenance
To keep the Machine in good condition, carrying out maintenance every time after use or once
a week will be needed. ※ Carry out maintenance depending on the amount of dust collected.
Wipe off Dust or Dirt on Each Sensor
The sensors are an important part of
detecting obstacles during autonomous
cleaning. Remove dust or dirt with
the supplied micro-fiber cloth.
Front
2D/3D Camera
（Sensor）
LIDAR Sensor
Cliff Sensor
If the dust or hair is caught in the brush, remove the brush from the Machine and clean.
1 1
Gently lay the Machine down
*Please ensure the steering
handle is not sticking out.
Insert each end of the brush
4 4
into the corresponding socket
of the brush compartment
Back
Cliff sensor
Remove Dust Caught in the Brush
2 2
Push the brush in to the right,
and pull toward you
Floor
□ Check the marks on the left and right ends of the brush.
□ Spin the brush and check the brush is installed correctly.
Discard any Dust in the Hopper Tray
Pull the tray out from the side by its handle.
The tray can be washed with water.
Wipe away any water when installing.
Left side Right side
3 3
Discard dust caught
in the brush
Right side
3