Table of Contents
Advertisement
Implement attachment
Electrics / Control system
Engine power
4.3.1 Calculating the ballasting
Required data
60029922 • 1 • 09/2020 • en
Taro
Tractor link arm*
*Tractor link arm implement attachment:
III:
Coupling point distances Cat. III
IV:
Coupling point distances Cat. IV
II/III:
Coupling point distances Cat. II
III/IV: Coupling point distances Cat. III
Electric power supply
Lighting
Taro
min. (kW/HP)
max. (kW/HP)
The permissible total weight, the permissible axle loads and the tyre load bearing ca-
pacity must not be exceeded when mounting or connecting implements.
The front axle of the tractor must always be loaded with at least 20 % of the curb
weight of the tractor.
Ø Check before road transport whether the tractor used is suitable for this imple-
ment and whether it is not overloaded.
Ø Weigh the implement separately. Since different equipment variants are pos-
sible, the weight of the implement must be determined by weighing.
T
Curb weight of tractor
L
T
Front axle load of empty tractor
V
T
Rear axle load of empty tractor
H
6 HD
Cat. III-III
Pin diameter Cat. III
Pin diameter Cat. IV
Pin diameter Cat. III
Pin diameter Cat. IV
12 V
Socket, 7-pin, see chapter Lighting
6 HD
200
250
Technical data | 4
27
Advertisement
Table of Contents
