Important Safety Information - Mytee Lite 8070 User Manual

Important Safety Information

Grounding Instructions
This machine must be grounded. If it should malfunction
or breakdown, grounding provides a path of least resis-
tance for electrical shock. This machine is equipped with
a cord having an equipment-grounding conductor and
grounding plug. The plug must be plugged into an appro-
priate outlet that is properly installed in accordance with
all local code and ordinances. Do not remove ground pin;
if missing, replace plug before use.
Improper installation of the equipment-grounding con-
ductor can result in a risk of electric shock. Be sure to
check with a qualified electrician or service person if you
are in doubt as to whether the outlet is properly grounded.
If the plug will not fit in the outlet do not modify either the
plug nor the machine's cord, instead have a proper outlet
installed by a qualified technician.
This machine is for use on a nominal 120-volt circuit and
with a grounding plug similar to the one in Figure 1 below.
If a proper outlet is not available, follow the illustrations
of Figure 2 & 3 to install a temporary-grounding plug. This
temporary work-around should be used only until a proper
outlet (Figure 1) can be installed by a qualified electrician.
When and if this type of adapter is employed, screw the
adapter's extended tab into place with a metal screw.
However, grounding adapters are not approved for use in
Canada.
Again, be sure to check the grounding pin for damages
and replace if necessary.
The Green, or Green-Yellow, wire in the cord is the
grounding wire. When replacing a plug, this wire must be
attached to only the grounding pin.
DO NOT use extension cords.
Please Note for America use only.
Grounded Outlet
Grounding Pin Grounded Outlet Box
Figure 1
Adapter
Metal
Screw
Tab for Grounding
Screw
Figure 2 Figure 3
Parts and Service
Please contact a Mytee service personnel or Mytee
authorized Service Center using Mytee original replace-
ment parts and accessories for repairs are needing to be
performed. When and if calling Mytee for support, please
have your Model and Serial Number available for faster
assistance.
Name Plate
The Model and Serial Number are located on the lower
half of the back of the machine near the power plugs and
will be required for ordering replacement parts. You can
use the space provided on the front of this manual to note
down both for future referencing.
Unpacking the Machine
When your new machine is delivered, please carefully in-
spect both the shipping carton and the machine for dam-
ages. If damage is evident, save both the shipping carton
and machine so that the delivering carrier can inspect it.
Contact the carrier immediately to file a freight claim if
there has been any damage.
Caution and Warnings
Symbols
Mytee uses the symbols below to signal potentially dan-
gerous conditions. Always read this information carefully
and take the necessary steps to protect personnel and
property.
Is used to warn of immediate hazards that will cause se-
vere personal injury or death.
Is used to call attention to a situation that could cause
severe personal injury.
Is used to call attention to a situation that could cause
minor personal injury or damage to the machine or other
property. When using an electrical appliance, basic pre-
cautions should always be followed, including the follow-
4